Controller features
- Pairing - link gates, sensors and remotes into logical series
- Setup branches in your ducting and control the minimum airflow
- Safety features - maintains the safety features of your dust collector & prevents a vacuum in the ducting
- No single point of failure - all SHUTR components act indepently
- No internet connection needed
- No network set up needed
- Configure and update firmware of your SHUTR components with the SHUTR Connect app
- Potential free contacts (1x NO & 1 x NC) - for switching the dust collector
SHUTR Connect™ app
- Allow for Easy and Fast pairing
- Connect to the controller using Bluetooth
- Visualize available SHUTR components
- Run diagnostics and show status
- Runs on iOS™ and Android™
Functions
- Pair & Unpair: Change, add or delete paired devices/series
- Update firmware over-the-air (OTA)
- Branches: define series for each branche
- Config: configure settings for selected device
- Backup/restore configurations
Controller settings
- Dust collector switch ON delay
- Dust collector switch OFF delay
- Pulse length for magnetic switch
- Dust collector minimum runtime
- Dust collector minimum off time
Global settings
- Protect against vacuum
- Gate delay for closing
- Sensor sensitivity
General settings
- Indicator LED's on devices ON/OFF
- Switch dust collector ON/OFF when gates are active
Airflow settings
Settings per branche
- Set minimum open gates per branche
- Set priorities to open gates per branche
Advanced settings
- Set minimum airflow per branche with priority settings to open gates
The app shows the percentage of airflow per series based on the diameter of gates used (total airflow is 100% when all gates are open).
Include existing pneumatic dampers by using a SHUTR sensor on the processing machine (sensor set to external / provide diameter in app).